Alamo DSEB-D16 User Manual Page 88

  • Download
  • Add to my manuals
  • Print
  • Page
    / 119
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 87
© 2003 Alamo Group Inc.
Section 9 - 5
A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03
Joystick Mounting 2 WD & 4 WD
Installing Wiring Harness
for Joystick:
(Continued)
4. Wires to be Connected. You will need to
find the wire from the switch that
activates the
Starter Solenoid for the Tractor This wire will need
to be cut to form 2 ends. You will need to locate the
Ignition Switch Power Wire; this wire will have
current only when Ignition Switch is on. This Wire
will have a wire Tee’d into it. (See Figure 9)
5. Wire Harness Through Cab. There is a
large rubber plug in floor; this is where the Joystick
wiring harness will be put through the cab floor.
This plug can be pulled up through the floor (See
Figure 10). it will be required to cut a hole in this
plug for the Wire harness to run through.
6. Insert it Wire harness through Floor
Plug till the 4 wires that are not in the wire Harness
are even with the Floor. The wires that are sticking
out of harness will be run under Floor mat and
under dash panel to switch or connected to the
tractor harness. These wires are made long be-
cause of the different places they can be con-
nected on various models.
7. Connecting Harness Wires. There are 4
wires that must be connected inside Tractor. 1.
Red Wire (power supply), 1 Black Wire (Ground)
and 2 Brown Wires (Neutral Safety Switch). These
will have to be spliced into Tractor circuits. (See
Figure 13).
*
FIGURE 9
Starter Wires
*
*
*
*
*
FIGURE 10
Rubber Plug
FIGURE 11
FIGURE 12
Page view 87
1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 118 119

Comments to this Manuals

No comments