Alamo DSEB-D16 User Manual Page 27
- Page / 119
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03
© 2003 Alamo Group Inc.
Section 3 - 6
Pump / Drive Assembly Instructions
Figure 14
Gap ? Check, this must have a gap
between Pump & drivesahft
Figure 15
Pump Retaining
Bolts (2)
Installing Pump: (continued)
5. Mount Pump to Pump Plate. Remove the
Bar that is slid through the Driveshaft Yoke and
push the Pump inward (See Figure 14). This will
make the two piece Driveshaft slide together al-
lowing the Pump to be pushed towards the tractor.
Do this untill the Pump is against the Pump Plate
(See Figure 15).
6. Install Pump Mounting Bolts. While holding
in on the Pump (See Figure 15) start the two
Pump Retaining Bolts. Make sure both Bolts are
started well before you stop supporting pump. The
Bolts should be snugged untill pump sits level
before you stop supporting it (See Figure 16). Let
go of the Pump, it may slide back some and leave
a slight gap between Pump and Mounting Plate
(See Figure 16).
7. Tightening Pump Mounting Bolts. There is
a shoulder on Pump Flange that must line up
through hole in Pump Mounting Plate (See Figure
14), if the Pump is slid back as in figure 14 try to
push it inward untill it is against Pump Mount Plate
as shown (See Figure 15). Slowly and alternating
from Left to the Right side, tighten the Pump
mounting bolts untill they are tight. DO NOT FORCE
Pump through Pump Mount Plate, if it will not freely
slide in check for a problem of some kind. Excess
force could damage Pump Housing. (See Figure
16). Do Not remove any Plastic caps from Pump
inlet or outlet at this time, keep all openings plugged
and sealed to keep them clean.
Figure 13
Figure 16
- ALAMO INDUSTRIAL 1
- Assembly Instruction Manual 1
- John Deere 6615 and 7615 1
- TO THE OWNER/OPERATOR/DEALER 2
- INTRODUCTION 3
- INDEX - ASSEMBLY INSTRUCTION 4
- Safety Section 1-1 7
- (SG-2) 9
- © 2003 Alamo Group Inc 10
- © 2003Alamo Group Inc 11
- Section 1 13
- Assembly 14
- Saftey Equipment: 15
- Frame and Boom: 15
- Hydraulic System: 15
- Rotary Mower Head: 15
- Flail Mower Head: 16
- Post-Operation Inspection: 16
- For Check List 17
- Section 2 18
- Rear Wheel Counter Weight 19
- Figure 1 19
- Figure 3 20
- Figure 2 20
- Section 3 22
- Figure 10 26
- Figure 11 26
- Figure 12 26
- Figure 14 27
- Figure 15 27
- Figure 13 27
- Figure 16 27
- Figure 17 28
- Figure 19 28
- Figure 18 28
- Section 4 30
- Frame Rail Set Up 31
- Frame Rail Installation 32
- Frame Stiiffener Kit 33
- High Frame Installation 35
- Rear Axle 39
- Floor Jack and 39
- Frame Rail 39
- Figure 20 40
- Figure 21 41
- Figure 23 41
- Figure 24 41
- Figure 22 41
- Figure 25 42
- Figure 26 42
- Figure 28 42
- Figure 27 42
- Figure 29 43
- Figure 30 43
- Figure 32 44
- Figure 31 44
- Figure 33 45
- Figure 34 45
- Figure 35 46
- Figure 37 46
- Figure 36 46
- Figure 38 46
- Figure 39 47
- Figure 40 48
- Figure 41 48
- Figure 44 49
- Figure 42 49
- Figure 43 49
- Figure 45 49
- Figure 51 51
- Figure 52 51
- Figure 54 51
- Figure 53 51
- Figure 56 52
- Figure 55 52
- Figure 57 52
- Figure 58 52
- Section 5 54
- Frame Rail Installation 4 WD 58
- Section 6 62
- Hyd. Tank - CWT Installation 63
- Decal Installation 64
- Section 7 66
- Boom Installation 67
- Front of Tank & 69
- Front of Tractor 69
- Hose Installation 70
- Section 8 72
- Common Problems: 75
- System Schematic 77
- MECHANICAL VALVE MODELS 79
- Section 9 84
- Optional Joystick Mounting 85
- Option Joystick Mounting 86
- FIGURE 5 86
- FIGURE 6 87
- FIGURE 7 87
- FIGURE 8 87
- FIGURE 9 88
- Installing Wiring 89
- Harness to Joystick: 89
- (Continued) 89
- FIGURE 16 90
- FIGURE 17 90
- FIGURE 18 90
- FIGURE 19 91
- FIGURE 20 91
- FIGURE 21 91
- FIGURE 22 91
- FIGURE 23 92
- FIGURE 24 92
- FIGURE 26 92
- FIGURE 25 92
- FIGURE 27 93
- FIGURE 28 93
- FIGURE 29 93
- Actual Pin Location 94
- IS SHOWN in this 94
- Illustration 94
- FIGURE 32 96
- FIGURE 33 96
- Section 10 98
- Figure 4 100
- Figure 5 101
- Figure 6 102
- Figure 7 103
- Figure 8 103
- Figure 9 103
- Section 11 104
- Fill Hydraulic Tank 105
- FIGURE 1 105
- FIGURE 3 FIGURE 4 105
- FIGURE 2 105
- Section 12 108
- Start-up Instructions: 109
- Post-Assembly Check List: 110
- Section 13 112
- FIGURE 3 113
- FIGURE 4 113
- Boom Swing Stop Installation 115
- FIGURE 10 115
- FIGURE 11 115
- FIGURE 12 115
- FIGURE 13 115
Related products and manuals for Tractor Alamo DSEB-D16
Tractor Alamo EAGLE 10/15 User Manual
(180 pages)
(180 pages)
Tractor Alamo SX15 User Manual
(160 pages)
(160 pages)
Tractor Alamo RHINO TX235 User Manual
(150 pages)
(150 pages)
Tractor Alamo Brahma 02968822P User Manual
(64 pages)
(64 pages)
© 2020, manymanuals.com. All rights reserved. | 0.440 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals