Alamo DSEB-D16 User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 119
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
© 2003 Alamo Group Inc.
Section 3 - 7
A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03
Install Front frame Rail Supports:
1. Remove Bolts from Tractor Frame
Rails. Find the front most 4 Bolts in the Tractor
Frame Rail, There are 4 on the RH side and 4 on
the LH Side. DO NOT REMOVE THE BOLTS
FROM BOTH SIDES AT THE SAME TIME,
ONLY do one side at a time the RH or the LH.
For illustration start with the RH Side (See
Figure 17). The RH & LH Frame Rail Supports
have a Right and a Left. They will not inter-
change and must be mounted on the correct
side. Notice the way they are built, the Plate part
that bolts to Tractor is longer in the front on both
LH & RH. Make sure the longest part is to the
front (See Figure 18).
2. Install Frame Rail Support RH Side.
This works best with a 2 man team. The RH
Frame Rail Support the is held on with the 5
bolts that Bolts that are supplied w/ mounting
kit. Start all 5 bolts with Lockwasher before any
of the 4 are tightened (See Figure 18). When
tightened down it will look like the picture in
Figure 18. Tighten the four retaining bolts for the
RH Frame Rail Support before lossening or
removeing the bolts on the LH side.
3. Install Frame Rail Support LH Side. Make
sure that the bolts on the RH side have been
tightened before removing the four bolts on the
LH side. The LH Frame Rail Support will install
the same as the RH side did. Remove the 4
bolts; Install the Front Frame Rail Support.
Tighten the 4 bolts through Tractor Frame Rail.
(See Figure 19).
Figure 17
Tractor Frame Rail
Bolts(5)
RH Frame
Rail Support
RH Tank
Mount Bracket
Figure 19
Mounting Plates on
Front Frame Rail
Support, the longer
part toward front on
RH and LH side
Pump / Drive Assembly Instructions
Right Hand Frame rail
Support Shown
Figure 18
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 118 119

Comments to this Manuals

No comments